nono is OMRON LUNA-I/LUNA-88K emulator runs on NetBSD and etc. It can also emulate SHARP X68030 and virt-m68k.
This is the same one that is contained in the source archive.
1.8.4 の変更点Changes in 1.8.4
:
Implement an NWB-225 video board partially for NWS-1750.
Implement an NWP-411A keyboard for NWS-1750.
Implement (not tested) mouse for NWS-1750.
Implement an AST interrupt on NWS-1750.
Implement SCC interrupt acknowledge cascade for NWS-1750.
Fix DIPSW bit 6, 7 on NWS-1750.
Change the serial console emulation to VT100 compatible.
Fix the handling of cases where the lower limit of DECSTBM exceeded the number of physical rows. These two fixes resolve the screen corruption in sysinst on NetBSD/virt68k after 11.0_RC7.
Remove DECLRMM, a feature introduced in VT420, from serial console emulation.
Fix a double bus fault caused by key input at the PROM prompt after a reboot when using the built-in PROM on LUNA-I.
Fix the stack pointer on X68030 Pluto-X. This resolves a dmesg corruption after a reboot on NetBSD/x68k using built-in IPLROM.- m88k(Fix): RTE 命令で SFIP/SNIP.V=0 のケースを実装。
Implement the case of SFIP/SNIP.V=0 on RTE instruction.- GUI(Update): LUNA のメニュー「モニタ>メインデバイス」を 「モニタ>デバイス」に名前を変更。
Rename a menu "Monitor>Main Devices" to "Monitor>Devices" on LUNA.- GUI(Update): LUNA の「ビットマッププレーン」モニタを「フレームバッファ」 モニタに名前を変更。
Rename a "Bitmap Plane" monitor to "Framebuffer" monitor on LUNA.- GUI(Fix): NWS-1750 の DIP-SW モニタのスイッチの上下を修正。
Flip switches on the NWS-1750 DIP-SW monitor upside down.- GUI(Fix): アクセス状況モニタのヘッダ部の描画が崩れることがあったのを修正。
Fix an issue where the header rendering might corrupted in the access status monitor.